Correct Maintenance Method of Integrated Solar Led Street Light
Integrated Solar led street light use sunlight as the primary source of energy, so they can be installed as long as there is sufficient sunlight, and because they are not contaminated, they are also called green products. In addition, the integrated solar LED street lamp is a new energy street lamp designed with a high-efficiency light source. It has high brightness, convenient installation, stable and reliable operation, no need to install cables, and does not consume conventional energy. long-lasting.However, if the integrated solar led street light is broken, how should it be repaired?First, test the core part of the integrated solar led street light, solar street light controller. If it does not turn on normally, a red light indicates charging, a flashing light indicates that the battery is full, and a yellow light indicates that the battery is low. If the light does not turn on properly, you need to check the battery voltage of the solar street light. If it is normal, you need to replace the solar controller.Secondly, if it is not a malfunction of the solar controller, it is necessary to further check whether the solar panel can be charged normally. If charging is not possible, there is a voltage but no current. At this time, it is necessary to check whether the connectors of the solar panel are connected and whether the aluminum foil has a current. If there is no current, it is basically determined that the solar panel has been scrapped. If there is current, pay attention to whether there is a cover on the panel, and the battery cannot be charged.Once again, test the integrated solar led street light battery. Since the batteries used by many manufacturers do not have a waterproof function, they may also cause a short circuit of the battery after water infiltration and cause voltage instability. Therefore, when testing, be sure to carefully observe the change in battery voltage with the depth of discharge and replace if it is not correct.Finally, detect if a solar led street light is damaged. If the insulation is worn, the current will also propagate through the solar pole and cause the street to short. In addition, if the integrated solar led street light will also illuminate during the day, it may be that the controller components have burned out.